75 Watt 4-Pin Ultraviolet Lamp Replacement

Replacement ultraviolet lamp suitable for various UV/filtration systems:

• Protect-UV WoH systems
• Radfire2700
• Davey (UV)
• Aquapro

75 watt lamp; 4 pin; 100/130 litre per minute (LPM)

Not available for online purchase. Please contact for details.

 

Contact Us

Category: Filtration System Servicing

The post 75 Watt 4-Pin Ultraviolet Lamp Replacement appeared first on Pristine Water Systems Shop.

The Pristine Water Systems replacement specifications:

• 4 pins at one end
• 850mm in length (including pins)
• 60 LPM
• 40 watt lamp

PW11040

The post 40 Watt 4-Pin Ultraviolet Lamp Replacement appeared first on Pristine Water Systems Shop.

The post Filter Housing Spanner appeared first on Pristine Water Systems Shop.

Test your water quality with the AqueousPro™ Test Strips. A quick, simple solution to ensure your water storage systems are free of bacteria and viruses.

Single-dip test procedure to test for water quality in a broad range of concentrations. When using the AqueousPro™ Water Sanitiser, the AqueousPro™ Test Strips provide accurate results from 0.50 to 100 ppm (mg/L) in under one minute.

AqueousPro™ Test Strip instructions

To confirm AqueousPro™ water sanitiser has effectively passed through all your pipework and taps, the following instructions should be actioned when using the AqueousPro™ water quality test strips.

1. Open all internal and external water outlets (taps, showers, sinks, etc) and run for a few minutes* to draw freshly sanitised water from the water tank, through your pump and into all pipework throughout the property.
   *NB: Tap run times may vary depending on distance water travels from tank to tap
2. Dip one test strip into water sample for approximately 2 seconds and remove. Wait 30 seconds. Hold test strip next to the colour match chart and review results.
3. Ensure that colour concentration is between 10ppm and 25ppm to confirm sanitised water is present within your water supply network
4. Allow adequate contact time. To confirm adequate contact time occurs to ensure the water sanitiser actively destroys bacteria and biofilm build-up in your water supply system, allow water containing sanitiser to sit in pipework for a minimum of 4 hours. Ideally up to 24 hours. Do not drink water during this period.
5. If test strip reads less than 5ppm after 24 hours, apply appropriate doses of AqueousPro™ and repeat test strip instructions

Store AqueousPro™ water quality test strips in a cool (but not refrigerated), dark, dry place. Avoid touching test strips or exposing to sunlight and moisture. Remove only as many strips as are required and seal bag immediately. Use or dispose of correctly. Test strips can be disposed as normal trash waste.

The post AqueousPro™ Water Quality Test Strips appeared first on Pristine Water Systems Shop.